Control arm- / trailing arm bush, Suspension arm, Repair kit, Wheel suspension 6773950

'Improved design for longer service life: MEYLE-HD parts 4-year warranty on all MEYLE-HD parts. No risk of leakage: MEYLE-HD full-rubber bushing with deliver enhanced durability. Compared to OE, MEYLE-HD is Engineered and quality approved in Germany. optimized rubber shape for a significantly longer lifetime. technically improved with reinforced inner parts, using higher quality materials or optimized design solution.

'Improved design for longer service life: MEYLE-HD parts 'Improved performance and service life: larger ball pin 4-year warranty on all MEYLE-HD parts. Better than OE: MEYLE-HD bushings with optimized inner MEYLE-KITS save time and money and make the daily Smarter than OE – this MEYLE-KIT innovates the usual With mounting materials, to fit most models. Please check deliver enhanced durability. Compared to OE, MEYLE-HD is Engineered and quality approved in Germany. fit accuracy before installation. life: maintenance. sleeve profile withstand greater forces and provide a longer workshop life more efficient. larger ball pin diameter of MEYLE-HD ball joint life and performance. technically improved with reinforced inner parts, using distributes forces over a larger surface area and minimizes higher quality materials or optimized design solution. part wear.

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.