Actual offers of Ignition coil NISSAN X-Trail (T31) 2.0 4x4 137 hp Petrol MR20DE

PLUG TOP COILS Recommendation - Due to operating time and Recommendation: Use grease for spark plug adaptors (ZKF 01
-
aging, the spark plug connector becomes brittle and thus reference No. 0 890 300 029),see accessories lists. untight in the sealing area of the spark plug, which may cause misfiring.1. Switch off the ignition. Wait for 15 min before demounting the ignition coil.This prevents voltage peaks that could destroy control devices.2. Remove the defective coil. 3. Apply a thin film of BERU spark plug connector grease ZKF 01(order no. 0 890 300 029) into the inner part of theconnector. 4. Attach the spark plug connector to the coil. 5. Mount the coil with the connector on the spark plug(heed the tightening torque). 6. Check the primary connector contacts for oxidation andclean it, if required.

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

9.6389

1.970.489