Actual offers of Turbocharger hose VW Sharan I (7M8, 7M9, 7M6) 1.9 TDI 90 hp Diesel 1Z
- Supplementary Article / Supplementary Info Info 2: without hose clip
- Diameter [mm]: 57
- Length [mm]: 280
- Weight [kg]: 0,239
- Item number: SKCHI-2030110
- Our price: 7,35 €
- Manufacturer: STARK
- EAN number: 4059191530106
- Condition: New
- Fitting Position: Right, Upper, Rear
- Material: Rubber with fabric lining
- Weight [kg]: 0,06
- Supplementary Info: Q+, original equipment manufacturer quality
- Packaging width [cm]: 4,5
- Packaging height [cm]: 4,5
- Packaging Depth [cm]: 5,8
- Item number: V10-3759
- Our price: 7,44 €
- Manufacturer: VAICO
- EAN number: 4046001688140
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
- TecDoc Engine Number: 1Z, AHU
- Turbocharger Line: Hot Side, Piping 1 to piping 2
- Inner Diameter 2 [mm]: 48
- Hose Length [mm]: 60
- Material: AEM (Ethylene Acrylate Rubber)
- Colour: black
- Observe broschure
- Item number: 09-0336
- Our price: 7,66 €
- Manufacturer: GATES
- EAN number: 5400608152272
- Condition: New
- for OE number: 1H0145834E
- Item number: 3356021
- Our price: 7,88 €
- Manufacturer: SASIC
- EAN number: 3660872426598
- Condition: New
- for OE number: 3A0145972A
- Item number: 96052
- Our price: 8,30 €
- Manufacturer: MEAT & DORIA
- EAN number: 808888919754
- Condition: New
- for OE number: 1H0 145 834 E
- TecDoc Engine Number: 1Z, AHU
- Material: Rubber with fabric lining
- Weight [kg]: 0,056
- Supplementary Info: Q+, original equipment manufacturer quality
- Packaging width [cm]: 5,8
- Packaging height [cm]: 5,7
- Packaging Depth [cm]: 6,6
- Item number: V10-4370
- Our price: 9,91 €
- Manufacturer: VAICO
- EAN number: 4046001788543
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Item number: 11451782301
- Our price: 9,94 €
- Manufacturer: VIKA
- EAN number: 224346131555121315551
- Condition: New
- Item number: 11451807101
- Our price: 10,63 €
- Manufacturer: VIKA
- EAN number: 224346140206641402066
- Condition: New
- Fitting Position: Charge Air Cooler, Upper
- Diameter [mm]: 57, 60
- Length [mm]: 59
- Item number: 82624
- Our price: 10,79 €
- Manufacturer: BUGIAD
- EAN number: 4043193826244
- Condition: New
above at intercooler
- Weight [g]: 465
- Quantity Unit: Piece
- Material, 3rd layer: CR (chloroprene rubber)
- Material, 2nd layer: Aramid
- Material, 1st layer: NBR (nitrile butadiene rubber)
- for OE number: 7M3145828
- Item number: 27953
- Our price: 11,25 €
- Manufacturer: IBRAS
- EAN number: 8698669279534
- Condition: New
- Outer Diameter 2 [mm]: 61
- Fitting Position: Charge Air Cooler, Left
- for OE number: 7M0 145834 A
- Diameter [mm]: 60
- Length [mm]: 145
- Item number: 87615
- Our price: 11,67 €
- Manufacturer: BUGIAD
- EAN number: 4043193876157
- Condition: New
Connecting pipe
- Supplementary Article / Supplementary Info Info 2: without clamps
- Fitting Position: Upper
- Material: Rubber with fabric lining
- short version
- Item number: 2400027
- Our price: 11,84 €
- Manufacturer: METZGER
- EAN number: 4250032538378
- Condition: New
If the turbocharger installed in the vehicle differs from the manufacturer's original installation, the correct charger air hose must be determined via the vehicle manufacturer.
- Inner Diameter 2 [mm]: 35
- Supplementary Article / Supplementary Info Info 2: without hose clip
- Fitting Position: Right, Upper, Rear
- Length [mm]: 58
- Material: Silicone
- Colour: black
- Item number: BTH1513
- Our price: 13,01 €
- Manufacturer: BORG & BECK
- EAN number: 5055936601352
- Condition: New
- Inner Diameter 2 [mm]: 48, 34
- Weight [g]: 166
- for OE number: 7M3145838F
- Length [mm]: 164
- Item number: 221961
- Our price: 13,04 €
- Manufacturer: ORIGINAL IMPERIUM
- EAN number: 8035670451830
- Condition: New
- Supplementary Article / Supplementary Info Info 2: with clamps
- Material: AEM (Ethylene Acrylate Rubber)
- Colour: black
- Item number: GT52-792
- Our price: 13,37 €
- Manufacturer: GT-BERGMANN
- EAN number: GT52-792
- Condition: New
- Connector Ø suction side [mm]: 57
- Connector Ø pressure side [mm]: 46
- Length [mm]: 558
- Weight [kg]: 0,495
- Item number: SKCHI-2030124
- Our price: 13,65 €
- Manufacturer: STARK
- EAN number: 4059191530380
- Condition: New
price incl. 19% VAT
excl. delivery costs
- Inner Diameter 2 [mm]: 47,5, 47
- Cooling Hose: Cold Side
- Hose Length [mm]: 130
- Fitting Position: Left
- Engine Code: ANU
- Material: PE (Polyethylene)
- Colour: black
- Weight [kg]: 0,12
- Suitable for vehicle type: PC (passenger car)
- Item number: 24SKV653
- Our price: 13,89 €
- Manufacturer: ESEN SKV
- EAN number: 5901947355725
- Condition: New
- Weight [kg]: 0,24
- Item number: 24SKV821
- Our price: 14,39 €
- Manufacturer: ESEN SKV
- EAN number: 224969142543131425431
- Condition: New
- Weight [kg]: 0,07
- Supplementary Info: Q+, original equipment manufacturer quality
- Packaging width [cm]: 6
- Packaging height [cm]: 5,5
- Packaging Depth [cm]: 5,5
- Item number: V10-2841
- Our price: 14,40 €
- Manufacturer: VAICO
- EAN number: 4046001604232
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Diameter [mm]: 57
- Length [mm]: 325
- Weight [kg]: 0,38
- Item number: SKCHI-2030073
- Our price: 14,41 €
- Manufacturer: STARK
- EAN number: 4059191529360
- Condition: New
- 1
- 2
- 3
- 4
- 5