Vehicle identification number: 4001510
Actual offers of Axle bushes FIAT Ducato I Platform/Chassis (280) 2.5 TD 92 hp Diesel 8144.21
- Fitting Position: Front, Rear Axle Left, Rear Axle Right
- Item number: 390217
- Manufacturer: UNIGOM
- EAN number: 2247309671150
- Condition: New
- Fitting Position: Front Axle
- Inner Diameter [mm]: 24
- Diameter [mm]: 51,5
- Item number: 4304107-00/80SHA
- Manufacturer: MPBS
- EAN number: 5904815810623
- Condition: New
- Fitting Position: Front Axle, both sides
- Height [mm]: 24,5
- Inner Diameter [mm]: 22
- Diameter [mm]: 48
- Mounting Type: Rubber Mount
- Rod / Strut: for guide bar
- Height 1 [mm]: 20,5
- Item number: F8-5084
- Manufacturer: OPTIMAL
- EAN number: 4031185076913
- Condition: New
- Inner Diameter 2 [mm]: 77
- Diameter [mm]: 95
- Fitting Position: Rear
- Item number: 08027187-00/80SHA
- Manufacturer: MPBS
- EAN number: 5904815804509
- Condition: New
- Fitting Position: Front Axle, both sides
- Rod / Strut: for guide bar
- Mounting Type: Rubber Mount
- Height [mm]: 24,5
- Inner Diameter [mm]: 22
- Height 1 [mm]: 20,5
- Diameter [mm]: 48
- Item number: FL4973-J
- Manufacturer: FLENNOR
- EAN number: 4030434048381
- Condition: New
- Fitting Position: Front Axle, Connector rod to console
- Mounting Type: Rubber Mount
- Rod / Strut: for guide bar
- Item number: 829 0548 10
- Manufacturer: FAG
- EAN number: 4014870428327
- Condition: New
- Fitting Position: Front axle both sides
- Mounting Type: Rubber-Metal Mount
- Item number: V24-1089
- Manufacturer: VAICO
- EAN number: 4062375013630
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.